On the current UD-ULTC4K, DISPLAY1 uses native USB-C DisplayPort Alt Mode. DISPLAY2 and DISPLAY3 use DisplayLink. Choose one connector per group and verify both the physical revision and software requirements.
Read the group labels, not just the sockets
Each of the current dock’s three labeled display groups offers a choice of HDMI or DisplayPort. The choice within a group is for one screen. Counting all six sockets as six independent outputs would misread the product.
Plugable identifies DISPLAY1 as a native connection from the computer’s graphics controller through USB-C DisplayPort Alt Mode. DISPLAY2 and DISPLAY3 instead use DisplayLink software and the dock’s USB graphics hardware. The manufacturer describes up to one 4K/60 screen per group, subject to the appropriate host and software conditions.
Identify the revision before following a diagram
Match the physical dock to the current six-video-connector layout and the labels DISPLAY1, DISPLAY2 and DISPLAY3. Do not silently apply the current diagram to an older unit because its product name resembles the listing. Capture the exact revision when you ask for support or report a mismatch.
Write down which connector belongs to which group for each monitor. “Two DisplayPort cables” is incomplete: one connection from DISPLAY1 and one from DISPLAY2 depend on different technologies, while two DisplayLink-group connections share the software requirement.
One working screen does not prove the other paths
If DISPLAY1 works but the other groups do not, inspect the DisplayLink installation and permissions before replacing all the monitor cables. If a DisplayLink group works but DISPLAY1 does not, establish whether the laptop’s selected USB-C socket provides native video.
These are fault-isolation directions, not diagnoses of a particular unit. Change one connection at a time, record the group and input, and test with the intended display mode. A successful single screen does not certify a full mixed native/software arrangement.
A three-screen specification is not our launch verdict
The manufacturer discusses three external displays; the NYBreaking launch planner focuses on one or two office screens. We do not turn the broader product specification into a supported three-screen result. Its two DisplayLink groups still need an allowed driver, a suitable version and the relevant Mac permission.
Protected video and demanding graphics workloads require separate attention. A workplace that permits native displays but forbids display software may find the software groups unsuitable. Review those constraints before treating this as a single-cable answer.
Check the bundle before buying another dock
Use the supplied power supply and the correct host cable for the documented revision. Confirm the required display cables, exact monitor inputs and charging behavior for your laptop; this record does not certify a charging wattage for your workload. Missing cables or a wrong supply can change the complete purchase cost.
The official output-technology guide is the starting point. The dock remains a research candidate here: source-backed component facts and a useful diagnostic sequence do not constitute an independently demonstrated full setup.
Sources and limits
These are component specifications, not a measured end-to-end test. Price, seller stock and regional bundles are not checked.
Check your exact equipment
A product record alone cannot confirm your laptop, output pair and cable combination.
Check the equipment you actually own Compare conditionsReport a correction · No active paid affiliate links.