How to make the perfect sandcastle, according to science

Summer vacation is here and no trip to the coast is complete without building a huge sandcastle that other beachgoers envy.

But as any vacationer knows, there’s nothing more frustrating than being halfway through your majestic creation when it collapses in a heap.

Fortunately, a British researcher has now provided a few tips on how to get the “perfect sandcastle,” according to science, and make it stand proud for hours.

Professor Matthew Bennett, a sedimentologist at Bournemouth University, suggests using an 8:1 ratio of sand to water and using jagged shell fragments in the mix.

According to one scientist, a few important tips will help you build a perfect structure that will not collapse

Professor Matthew Bennett, a sedimentologist at Bournemouth University, suggests using an 8:1 ratio of sand to water and using jagged shell fragments in the mix

Professor Matthew Bennett, a sedimentologist at Bournemouth University, suggests using an 8:1 ratio of sand to water and using jagged shell fragments in the mix

Tips for the perfect sandcastle

– Combine eight parts sand with one part water

– Mixing is important: make sure each grain is water-coated

– Choosing angular grains of sand will help them bond together

– Shell fragments are also good for increasing strength

– Use a round bucket (no squares with turrets)

He also says to use a simple round bucket – not a square bucket or one with turrets – which help keep the mixture compact – and provide you with the sturdy building blocks to build a mighty sand fort.

“Whether we prefer water sports or relaxing with a good book, the humble sandcastle is often a seaside must,” said Professor Bennett.

“The modest castle with perfect towers, battlements and moat is okay, but it’s the huge castles that break the beach horizon that inspire awe and wonder in passers-by.”

The first step is choosing the right sand, and the academic says that “angular” grains of sand help build a strong sand castle because they can interlock, just like a wall of bricks.

Circular grains, on the other hand, tend to slide against each other and are therefore a poorer choice – although it can be difficult to tell the difference with the naked eye.

If you’re not sure, incorporating small jagged shell fragments into the mix can help augment this interlocking formation and give the castle more structural integrity.

Incorporating a specific ratio of sand and water should keep your fort from crumbling or turning into a mudslide (file photo)

Incorporating a specific ratio of sand and water should keep your fort from crumbling or turning into a mudslide (file photo)

Professor Bennett advises sandcastle builders to add one part water to every eight parts sand – meaning that for every bucket you fill during construction, it should be about 12 percent water

Professor Bennett advises sandcastle builders to add one part water to every eight parts sand – meaning that for every bucket you fill during construction, it should be about 12 percent water

When you start building your sandcastle, the best approach is to collect shovelfuls of dry sand, as you need to control the amount of water that goes into it.

Professor Bennett advises sand castle builders to add one part water to every eight parts sand – meaning that for every bucket you fill during construction, it should be about 12 percent water.

An 8:1 ratio of sand to water is perfect because it provides just the right amount of surface tension – the force that causes water molecules to be attracted to each other.

Too little water and the surface tension can’t keep the grains of sand together, but too much water and the water turns into a lubricant, causing the castle to collapse and begin to flow with the water.

8:1 is the sweet spot between a castle that crumbles like a fruit topping (not enough water) and a castle that flows like a muddy landslide (too much water).

‘The water film between individual grains of sand gives sand its strength,’ says Professor Bennett.

“Too much and it smears one grain over another, but just right and it binds them tightly.”

For this reason, it’s important to mix thoroughly, make sure each grain of sand is water-coated, and pack the bucket to tighten the tiny water bridges that hold the grains together.

Following these steps should allow one bucket full of your mixture to support the weight of another, helping to create the biggest fortress on the beach.

Weather can affect the sturdiness of your structure where the slightest wind can blow it over, so you may want to opt for remote edges of the beach, perhaps sheltered by natural rock promontories.

Professor Bennett was part of a 2004 study comparing sand from the 10 most popular beaches in the UK.

The red sands of Torquay in Devon were the best for castle building, followed by Bridlington second and Bournemouth, Great Yarmouth and Tenby third.

Unfortunately, some famous beaches in the UK, including Brighton Beach, are useless for building sand castles for one simple reason: they have stones instead.

Planning a UK holiday? Prepare for bad weather! Experts reveal why rain and cooler temperatures make summer last

It’s fair to say it’s been a somewhat chaotic British summer.

Last month’s heat wave brought temperatures in excess of 86F (30C) making it the UK’s hottest June on record. But as July came, so did the rain.

Even worse, forecasters now expect this gloomy weather to continue for much of August, dashing hopes of a warm end to the summer break.

That is in stark contrast to the extreme heat most of Europe experienced, as successive heat waves ushered in record-breaking temperatures and wildfires on the Greek islands of Rhodes and Corfu.

So why has Britain had rain when the continent has been plunged into unbearable heat? The answer, Met Office experts and scientists have told MailOnline, lies in the arrival of a series of low-pressure systems over the UK held in place by a ‘blocked weather pattern’.